1 Piece Stainless Steel Pendant Claw Setting with Loop Hypoallergenic

Grade = 304 Stainless Steel

Total length = 79mm

Total width = 59mm

Claws specifications = 2x0.8mm

Loop hole = 10 x (6mm (at widest point))

Polished finish

Easy to use

1) Lay your cabochon on top of the claws to predetermine if its going to be an appropriate size and shape prior to any bending
2) Can trim claws a little for smaller pieces, de-burr with fine sand paper or mechanical polishing wheel
3) Glue is not needed as you will achieve a good hold. However you can glue parts where the claw touches the claw prongs to add more security on sides and back, there is very minimal movement, that is not noticeable when worn
4) Quick to assemble
5) First most important step is to bend the top claw with loop into position, making sure your loop position sits around were you need it too, then close the others in no particular order